Product Manual

4
6. Secure the 3 sections of the screen together in 6 places
using #8 screw, #8 lock washer, two #8 at washers, and #8
nut. Do not overtighten.
#8 screw
#8 lock washer
#8 flat washer
#8 nut
#8 screw
#8 lock washer
#8 flat washer
#8 nut
Assembly
1. Make sure you have all the parts needed. If any
shortages are found, contact your Kasco representative
immediately.
2. Place oat on motor housing. The power cord notch on
the oat should line up with the cord. See diagram below
of bottom side of oat. The 3 bolt holes in the oat should
line up with bolt receptacles on unit.
power cord notch
3. Use one of the 1/4”-20 x 3-1/4” Phillips Pan Head
Screws, one 1/4” split washer, and a 1/4” Flat Washer to
secure the oat. Make sure the split washer goes between
the bolt head and the at washer. Insert screw with washers
through bolt hole in oat. Tighten until snug with a Phillips
Head screw driver and repeat for 2 remaining screws.
4. Set motor housing and oat upside down on a at
surface.
5. Bring the 3 bottom screen sections together.