Product Manual

5
All other nozzle options require the following
assembly:
1. Place the ow straightener in the fountain tube
making sure it rests securely against the tube and the
holes line up. Attach the straightener using four #6 x
3/4” screws.
IMPORTANT: Make sure there is no gap between
the tube and ow straightener and that the screws
are tightened down securely. Loose screws or a gap
can lead to reduced performance.
#6 x 3/4” screw (4)
Make sure there is no gap
2. Place the oring in the oring groove on the ow
straightener.
7. Make sure the cord is coming out of the notch in the
oat before attaching the screen to the oat.
8. Align the screen to the oat using the picture to guide
you. Attach the screen to the oat in 3 places using 1/4”
x 1 3/8” bolt, 1/4” lock washer, two 1/4” at washers, and
1/4” nut. Do not overtighten.
1/4” flat washer
1/4” nut
1/4” lock washer
1/4” x 1 3/8 bolt
Align this screen
feature with this
float feature
9. Flip the unit back over so that the stainless steel can is
resting on a at surface. Use the Nylon Cable Tie included
to secure the power cord to a molded hole in the oat to
prevent cord damage if there is no strain relief on the cord.
If you purchased the 150’ or 200’ cord, the cord contains
a metal strain relief, you can use the chain connector and
attach it to one of the rope loops by the oat. If installing
a new Quick Disconnect, refer to Quick Disconnect
Instructions included in the cord box. The unit is now
ready for nozzle choice and assembly.
Nozzle Options and Assembly
V shaped pattern:
Requires no ow straightener or nozzle assembly.
Store those parts in a safe place for future use. This
V pattern provides the highest ow rate and aeration.
Pattern size is 6’ High by 13’ diameter.