Product Manual

ManualsBrandsKasco ManualsDecorative FountainsAerating Fountain — 3/4 HP, 120V, 100-Ft. Cord

Cord Gauge Chart

Length Gauge 3400 3400H

4400H

4400

50’ 16 x

50’ 14 x x

100’ 14 x x

100’ 12 x

150’ 12 x x

150’ 10 x

200’ 12 x x

200’ 10 x

250’ 12 x

300’ 12 x

400’ 12 x

Unit Specs

Model Voltage Amps Lock

rotor

amps

Control

box con-

nection

Fountain

connec-

tion

3400JF 110-120 6.7 18 C-25

plug in

Plug into

C-25

3400HJF 208-240 3.3 9 Hardwire

C-85

plug into

or hard-

wire C85

4400JF 110-120 10.7 40 C-25

plug in

Plug into

C-25

4400HJF 208-240 5.3 20 Hardwire

C-85

plug into

or hard-

wire C85

Parts Included

# Item Part# Qty

1 Fountain 1

2 Float 242001 1

3 1/4-20 x 4” Phillips Pan Head

Screw

251220 4

4 1/4” split washers 840537 7

5 1/4” (3/4” OD) Flat Washer 251300 10

6 1/4 -20 x 1-3/4” Hex Head Bolt 475630 3

7 Bottom Screen Section 361540 3

8 1/4”-20 Nut 840536 3

9 #8 nut 771034 6

10 #8 at washer 361543 12

11 #8 lock washer 771033 6

12 #8 x 3/4” screw 361545 6

Mooring ropes 990700 2

cable ties 415038 9

1110

9 12

DWG. NO.

XXXX-XXXX-XX

DO NOT SCALE DRAWING

C.A.D. GENERATED DRAWING

800 DEERE ROAD

PRESCOTT, WI 54021-1241

THIS DRAWING CONTAINS PROPRIETARY

INFORMATION AND SHALL NOT BE USED,

REPRODUCED OR DISTRIBUTED WITHOUT

THE PRIOR WRITTEN CONSENT OF

KASCO MARINE, INCORPORATED

.02 [.508] .XX

.010 [.254]

.XXX

.005 [.127] ANGULAR

0.5

UNLESS OTHERWISE SPECIFIED

DIMENSIONS ARE IN INCHES.

DIMENSIONS IN [ ] ARE MILLIMETERS.

TOLERANCES ON:

THIS DOCUMENT HAS BEEN ISSUED

FOR ENGINEERING INFORMATIONAL

PURPOSES ONLY. ANY REVISIONS

TO THE CONTENT OF THIS DOCUMENT

MUST BE INCORPORATED INTO THE

ORIGINAL CAD FILE.

THIRD ANGLE PROJECTION

TITLE:

XXXX-XXXX-XX

SHEET 1 OF 1

FINISH:

MATERIAL:

SCALE: 1:20

from hard water deposits and/or algae.

(See Maintenance Recommendations.)

It is extremely important that proper and sufcient

voltage (120V or 240/208V) is supplied to the Foun-

tain motor. Each 120V Fountain is supplied with a UL

and CSA approved C-25 GFI Protected Control Box.

The Fountain is to be plugged into the C-25 outlet

labeled “UNIT” and the C-25 plugged into a properly

grounded receptacle (See C-25 Instructions on page

12). Each 240V Fountain is supplied with a UL and

CSA approved C-85 GFCB Protected Control Panel.

The Fountain is to be hardwired into C-85 panel. The

C-85 must have 4 wire service (L1, L2, neutral, and

ground) installed by a qualied electrician. (See Wir-

ing Instructions). It is extremely important to test the

GFI breaker in the control panel upon each installation

and reinstallation and every month thereafter to ensure

proper operation.

UNIT STORAGE

When storing units during the offseason, it is impor-

tant to store them upside down if they are going to be

sitting for long periods of time. Units that sit upright

on a shelf for many months, or even years have a

greater likelihood of seals drying out. Storing upside

down will ensure oil is lubricating the seals and pre-

vent drying.