Product Manual

5
#8 screw
#8 lock washer
#8 flat washer
#8 nut
8. Make sure the cord is coming out of the power cord
guide in the oat before attaching the screen to the oat.
9. Use a stainless steel Bottom Screen Clip, 3/8”-16 x
1-3/8” Bolt, two 3/8” Flat Washer, and 3/8”-16 Nylon Lock
Nut to secure the screen to the oat. Align a clip so the two
prongs overlap the rim of the screen as seen in the picture.
Insert bolt with washer so the top of the bolt is facing the
top of oat (now in down position). Place the second
washer and the locking nut with nylon insert on the end of
the bolt and tighten using the 9/16” (14mm) Socket and
Ratchet on the nut end and the 9/16” (14mm) Wrench on
the bolt end. Tighten until snug and repeat with remaining
clip.
3/8” lock nut
3/8” flat washer
Bottom screen clip
3/8” flat washer
3/8” bolt
Bolt holes
power cord
guide
5. Use one of the 1/4”-20 x 3-1/4” Phillips Pan Head
Screws (Part 3), one 1/4” split washer (Part 4), and a 1/4”
Flat Washer (Part 5) to secure the oat. Make sure the split
washer goes between the bolt head and the at washer.
Insert screw with washers through bolt hole in oat
Tighten until snug with a Phillips Head screw driver and
repeat for 3 remaining screws.
6. Turn secured assembly upside down so the top of the
oat (logo side) is face down on the at surface. Bring the
3 bottom screen sections (part 9) together.
7. Secure the 3 sections of the screen together in 6 places
using #8 screw (Part 15), #8 lock washer (part 14), two
#8 at washers (part 13), and #8 nut (part 12). Do not
overtighten.
#8 screw
#8 lock washer
#8 flat washer
#8 nut