Product Manual

6
A. Aerator (Unit with cord or unit with Disconnect)
(1)
A1. Cord in separate box (1) (depending on size of
cord)
B. Float in separate box (1) (Diagram to Right)
1. 3 Float Sections (1)
2. Top Float Bracket (3)
3. Bottom Float Bracket w/ 50’ rope (3)
4. 9” x 3/8” Black Coated Bolt (6)
5. 3/8” Lock Nut (6)
6. 1/4” x 1” Bolt (6)
7. 1/4” x 3/4” Bolt (3)
8. 1/4” Lock Washer (12)
9. Bottom Screen (1)
10. Top Screen (1)
11. Top Screen Clip (3)
12. 1/4” Nut (6)
13. Bottom Screen Clip (3)
14. 1/4-20 x 3/4” Brass Screw (3)
15. Mesh screen (1)
16. Cable ties (10)
C-85 Control Panel in separate box (1) for 8400VFX
C-95 Control Panel in separate box (1) for 5.1VFX
NOTE: Extra hardware may be included.
TOOLS & SUPPLIES NEEDED
• Anchors or stakes for installing unit (3)
• Philips head screw driver for mounting C-85
• 240V Electrical Supply near pond on a post with
room for mounting the C-85
• Three 12” long galvanized 1” diameter pipe for
weighting ropes (optional)
• #10 x 1” long or longer screw(s) for mounting the
C-85 (4)
• 7/16” Socket & Wrench (1)
• 7/16” Wrench (1)
• 9/16” Socket & Wrench (1)
• 9/16” Wrench or adjustable crescent wrench (1)
• Flat head screw driver (1)
8400VFX, 2.3(H)VFX, 5.1VFX, 5.3(H)VFX
Assembly
1. Remove all contents from package and place on
a clean, at surface. Inspect the shipment for any
damages. If damages are found, immediately notify
your carrier and your Kasco Marine, Inc. representa-
tive. Next, cross reference the parts included in the
shipment with the Parts Included section in this man-
10. Turn the assembly upright again. At this time, if
the cord contains a metal strain relief, you can use the
chain connector and attach it in one of the opening at
the rope placement. The chain connector will easily t
if installed from the bottom or top side of the opening.
It will not t if installed from side of opening. Use the
Nylon Cable Tie included to secure the power cord to
a molded hole in the oat to prevent cord damage if
there is no strain relief on the cord. If a Strain Relief
is present on the cord, you may disregard the Nylon
Tie. On cords with a Quick Disconnect, the discon-
nect should be tightened properly to avoid leaking.
If installing a new Quick Disconnect, refer to Quick
Disconnect Instructions.
8400VFX, 2.3(H)VFX, 5.1VFX, 5.3(H)VFX
Parts
8400VFX, 2.3VFX PARTS INCLUDED
5.1VFX, 5.3VFX PARTS INCLUDED