User's Manual

ADSL Router User Manual
5
 Subscription for ADSL service. Your ADSL service provider should
provide you with at least one valid IP address (static assignment or
dynamic assignment via dial-up connection).
 One or more computers, each contains an Ethernet 10/100M Base-T
network interface card (NIC).
 A hub or switch, if you are connecting the device to more than one
computer.
 For system configuration using the supplied web-based program: A web
browser such as Internet Explorer v5.0 or later, or Netscape v4.7 or
later.
1.4 Factory Defaults
The device is configured with the following factory defaults:
 IP Address: 192.168.1.1
 Subnet Mask: 255.255.255.0
 SSID: WLAN
 Encapsulation: RFC 2516 LLC
 VPI/VCI: According to local information
1.5 Warnings and Cautions
 Never install telephone wiring during storm. Avoid using a telephone
during an electrical storm. There might be a risk of electric shock from
lightening.
 Do not install telephone jacks in wet locations and never use the product
near water.
 To prevent dangerous overloading of the power circuit, be careful about
the designed maximum power load ratings. Not to follow the rating
guideline could result in a dangerous situation.
 Please note that telephone line on modem must adopt the primary line
that directly outputs from junction box. Do not connect Router to
extension phone. In addition, if your house developer divides a
telephone line to multi sockets inside the wall of house, please only use
the telephone that has connected with the splitter of ADSL Router when
you access the Internet.