Config Guide

68 of 122
Operating the Reader Using the ReaderStart Software
1
2
3
Fig. 34: Ethernet section
Establishing a Secure Connection
✔ The connection to the reader has not yet been established.
1. In the Ethernet section, click the box next to the lock symbol (① in Fig. 34 ).
2. Click Search for Readers (②) or Connect (③).
➯ The following pop-up window appears:
1
2
3
4 5
3. Type in the user name at User (①). The default user name is root .
4. Enter the default password UHF-RFID-Dev at Password (②).
Tip
You can change the password under Linux module ▶ Connection config ; see Linux Module, p.60.
5. If you want to use the key file instead, click the box at Key file (③).
➯ A pop-up window to select the key file opens.
6. Select the key file.
7. Click OK to establish the secure connection.
➯ It is possible to configure the secure connection under Linux module ▶ Connection config ; see also Linux Module,
p.60.
Loading Factory Default Settings
When resetting the reader to factory default, the ReaderStart sends out a UDP broadcast cmd. It is only possible 30 sec-
onds after power rebooting.
Note that this command also resets the Linux module settings, such as Linux password, network name, IP
address, deactivates the auto start of the apps etc.
1. In the Ethernet section, click Search for Readers .
2. Select the reader onto which you would like to load the factory default settings.