Config Guide

98 of 122
Operating the Reader Using the ReaderStart Software
14.8.3 Change Reader Parameter
Change reader parameter allows to change all reader settings using their respective configuration IDs.
4
6
1
2
4 5
3
Fig. 59: Expert settings 2: change reader parameter
①
Parameter ID selects the parameter ID
②
Parameter value
shows or sets the parameter value
The value is either decimal or hexadecimal, it is possible to switch between dec and hex .
③
Active parameter
set
shows the current active parameter set
④
Get
reads the value of the current parameter set of the reader and shows it at ②
⑤
Set
writes the parameter value (②) into the selected parameter ID (①)
14.8.4 Select Filter Settings
By means of these settings, it is possible to filter certain tags, e.g. to only read tags with the defined data in the respec-
tive memory banks. It is possible to set up to 32 filters.
7
8
9
10
11 12
2
4 5
1
2
3
4
5 6
Fig. 60: Expert settings 2: select filter settings
①
Filter selects a filter
②
Target
selects the tag target session
► Make sure the target matches the session set in ⑲ Fig. 57,p.97 .
③
Action
selects the action; see also EPCglobal Gen 2 Specification (p. 73)
Tip
► To see the description of an action, hover over the Action field.
➯ The description of the action appears in the tooltip:
④
Memory bank selects the memory bank ( RFU / EPC / TID / User )
⑤
Save select filter
data to file
saves the select filter data to file
⑥
Load select filter
data to file
loads the select filter data from file
⑦
On activates or deactivates the select filter
⑧
Bit pointer sets from which memory address the filter compares the mask data
⑨
Mask length sets the mask length (0–255)