Config Guide

108 of 122
Operating the Reader Using the ReaderStart Software
14.10.1 Polarisation
2 3
1
9
Fig. 72: @KRAI: polarisation
①
sets the polarisation of the antenna
If there are several types of polarisation selected at the same time, the antenna configuration
changes after every inventory.
②
Get polarisation reads the current polarisation information of the antenna
③
Set polarisation sets the polarisation on the antenna
14.10.2 LED
Depending on the features that are integrated in the antennas, it is possible to control/configure the LEDs.
2
3
1
4
5
6
7 8
Fig. 73: @KRAI: LED
①
LED 1 – 4
selects the function of the LED 1–4
► For functions, see Chapter Selecting Functions, p.88
②
Turn-o time sets the turn-o time for LED
③
Get LED config shows the current LED configuration
④
Set LED config sets the new LED configuration
⑤
LED selects between LED 1–4
⑥
Duration
sets the duration of how long the LED is on; only if protocol access is selected in ①
⑦
Set LED on
switches the LED on for the duration in milliseconds selected in ⑥; if the duration is set to 65535
ms, the LED is permanently on
⑧
Set LED o switches o the selected LED