Installation Manual Part 2
Installation manual Reader 53
Modications, misprints and errors excepted
English
6. Operating the reader
The row "number of unique tags" species how many different tags were read.
When the Tag count is very high (> 200) the detection of the tags can be speeded up, by commanding the reader may
change to new "select command" (see EPC global standard (E)).
This can be tested by selecting "Expert Parameters" directly in read mode. If the read operation box is ticked with
"Transmit Select If No Filter Is On", a "Select" is sent in each "Inventory". This means that all the tags that are dened at
this time in the eld will be reset. It can also happen that tags that have been read are sometimes reset and re-recorded
again. In order to capture only new tags, a renewed "Select" can be prevented. This tick box is cleared on "Transmit
Select If No Filter Is On" and thus all tags dened only once read. This selection result is that no time is lost due to a
re-read. Please note, however, that tags in which the read operation was interrupted, they cannot be retrieved! Thus,
it may be that not 100% of the tags are read. Therefore, this parameter should be used with care in order to achieve
top results.
To display Tag phase and frequency during basic reading, the option “Show frequency and tag phase”
Should be selected in options menu.
6.3.1. Display Tag phase and frequency
With the change of the tag phase, a movement of the transponder can be detected.
The frequency and the tag phase will be stored with all read results in CSV-format, if the button “ Store to le” is se-
lected