Installation Manual Part 2
Installation manual Reader 42
Modications, misprints and errors excepted.
English6. Operating the reader
6.1.3. Ethernet header
6.1.2. USB header
If a RRU4 is connected to the PC via USB, the unit is installed in the system as a USB HID-compliant device.
Correct logging in can be seen in the program if a reader number appears in the drop-down menu. This number is
unique for each reader. If several readers are connected to the PC, the related reader can be selected on this menu.
Clicking on Open now establishes the connection between the reader and PC.
The Ethernet connection can be achieved by linking the reader into an existing network, or by a direct connection
between the reader and a control computer. For direct connection of the reader to the PC, a cross-link cable
is required, unless the LAN interface on the PC supports “auto-mdi-x”. Alternatively two standard patch cables
and a switch can be used.
6.1.4. Reader to factory default via TCP/IP- broadcast cmd
To reset the reader to factory default, the ReaderStart SW will send out a TCP/IP- broadcast cmd. This is only possible
20 seconds after power rebooting. For this select at the folder “Communication”, press “Search for Reader”.
All reader in the network will be listed. Select the correct reader and press right mouse button.
The following question „Are you sure….“ will be answered with „YES“.