Installation Manual Part 2
Installation manual Reader 66
Modications, misprints and errors excepted.
English
6. Operating the reader
6.6.2. Expert settings 2
Figure: Expert settings 2 tab
The Expert settings 2 tab is split into four headings for further conguration of the Kathrein RRU4 reader. The default
parameter set can be changed, one parameter set copied into another,reader parameters read to determine their ID
and select lter settings congured.
The Default parameter set rubric allows conguration of the parameter set that is loaded from the EEPROM into the
RAM when the Kathrein RRU4 reader is started.
The Copy parameter set header allows one parameter set to be copied into another. On successful completion of the
copy operation, the Copy button glows green briey and a corresponding message is displayed in the status window,
otherwise the Copy button glows red.
The Change reader parameter header allows all the Kathrein RRU4 reader settings to be changed using their
respective conguration IDs. After selection of the parameter ID, the corresponding value of the current parameter set
of the Kathrein RRU4 reader is read by clicking on Get parameter value and displayed in the eld parameter value,
optionally as a decimal (dec) or hexadecimal (hex) value. A value that has already been read can be converted to dec
or hex by pressing the radio button. The Set parameter value button writes the value stated in the Parameter value
eld into the selected parameter ID. The two actions (read and set) are shown by the respective buttons glowing
the respective colour to indicate success and failure, and a message appears in the status window accordingly.
In the Select settings area, lters can be set which are brought into effect by means of a Select command. This
offers the facility to lter out certain tags, or to detect only tags with certain dened data in the respective
memory banks. Up to 32 lters can be set in total. Successful reading of the values of the selected lter and
successful writing of the lter values is indicated by the respective button glowing green and a text appearing
in the status eld. Otherwise the respective button glows red and a description of the error is output.