User's Guide

10 of 146
Safety Instructions
NOTICE
Risk of malfunction!
► Make sure the reader is properly grounded according to the corresponding national standards.
► Make sure that the diameter of the ground cable is min. 6 mm
2
(typ. 10 mm
2
).
► Make sure to ground the reader such that the distance between the reader ground point and the
ground point in the building is as short as possible.
► Note that the equipotential bonding does not replace lighting protection.
6.2 CE Marking for the Kathrein RFID Readers with the Type Designation ETSI
WARNING
Dangertolifeduetoradiationelectromagneticeld!
This reader is designed ETSI
for operation according to EN302208. In some circumstances, heart
pacemakers may suer interference if wearers are close to the antenna when the unit is in operation
(reader and antenna).
► When the unit is operated with antennas connected, comply with the human exposure regulations
in accordance with EN 50364.
► Ensure a minimum clearance of 35cm between the antenna and the human body.
► Comply with the operating instructions for RFID antennas.
► In case of doubt, make sure people with peacemakers contact the manufacturer of their peace-
maker or their doctor.
6.3 FCC and ISED Canada Regulatory Information
The operator and the specialist company which carries out the installation are responsible for ensuring that
only certied systems are used in the United States. Use of this system in any other combination (e.g. sev-
eral antennas which transmit the same information in the same location) is expressly prohibited. Changes
or modications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
To meet the certication regulations according to Part 15 of the FCC regulations in the United States:
► Make sure the operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
► Make sure the unit is properly installed, see
FCC RF Radiation Exposure Statement and ISED RF Radia-
tion Exposure Statement .
The readers with the grantee code WJ9 are designed to operate under FCC Part 15 and can be found at the FCC home-
page. This device complies with Part 15 of the FCC Rules and with ISED license-exempt RSS standard(s).
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference;
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
ISDE
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d'Innovation, Sciences
et Développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes:
(1) Cet appareil ne doit pas causer d'interférences;
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement
indésirable de l'appareil.