User's Guide

117 of 146
②
Info
shows the information about the tag manufacturer and the chip type
► Click on the information symbol.
➯ The information about the tag is shown:
16.9.2 Password for Operation
1
Fig. 14: TestGen2: password for operation
①
Password sets the password for the tag operation in the hexadecimal format
16.9.3 Write EPC
In this tab, it is possible to change the EPC of the tag.
2
3
4
1
Fig. 72: TestGen2: write EPC
①
New EPC
enters an EPC in the hexadecimal format
Make sure to comply with the maximum EPC length supported by the tag. If the max-
imum length is exceeded, the tag will return an error.
②
Auto
increment
activates or deactivates increasing the EPC by one with each successful writing process
③
Write EPC to
selected tag
writes the EPC on the selected tag
④
Write EPC to
tag in eld
writes the EPC entered in 1 to a single tag
► When using this command, make sure there is only one tag in the eld. Otherwise, an error
message is displayed in the status eld.