User's Guide

127 of 146
16.11.2 Installing an App
This chapter describes installing an app shown on the example of AccessManager . You can install all other
apps following the instructions described below.
✔ The ReaderStart software is installed.
✔ The reader is connected to a PC.
1
Fig. 15: AppManager: installing an app
1. Go to https://www.kathrein-solutions.com/products/software/interface-software/accessmanager.
2. Downoad the app.
3. If the downloaded app is in the zip format, extract a .tar le. Make sure not to extract the .tar le!
4. Start the
ReaderStart software.
5. Go to the
AppManager tab.
6. Click on
Install app (①).
➯ A pop-up window to select the le with the app opens.
7. Select the le with the app. Make sure it is the .tar le.
8. Click
Open .
➯ A pop-up message with the progress bar for the installation process appears for the duration of the
installation.
After the app has been successfully installed, the corresponding message is displayed in the status eld and
the app interface is shown in the
AppManager tab:
Tip
► To see all the installed apps, click the menu symbol at (①).
➯ The installed apps are displayed:
1