User's Guide

128 of 146
Operating the Reader Using the ReaderStart Software
16.11.3 Activating an App License Key
This chapter describes activating the app license key shown on the example of AccessManager . You can
activate all other apps in a similar way following the instructions described below.
✔ The ReaderStart software is installed and running on the PC.
✔ The reader is connected to the PC.
✔ The
AppManager has been installed in the ReaderStart software, see Installing an App
1. Go to the AppManager tab.
2. To see all the installed apps, click the menu symbol at (①).
➯ The installed apps are displayed. The
AccessManager is shown in red, which means the app has not been
started yet:
2
1
3. Click Start App (②, see gure above).
➯ The
AccessManager is started and is shown in green (①, see figure below). The hardware key is displayed at
(②, see figure below):
2
1
There are two options to activate the license key, one is a paid version, which you can only use if you have
purchased the product and received the product key. There is, however, the demo version which is free of
charge but limited to 8 hours if the app is running.