User's Guide

65 of 146
1
2
3
4
Fig. 38: Establishing connection to the reader
Establishing the Connection via an IP Address
1. Click the IP address eld (① in ).
2. Enter the IP address.
Establishing the Connection Using a Host Name
1. Click the Name eld (② in ).
2. Enter the host name of the reader.
If you do not know the name of the reader, click
Search for Readers .
➯ The readers found in the network are shown with their names, see ⑤ in
.
Tip
► To allow only secure SSH connection with an encrypted transmission to the reader, check the box next
to the lock symbol (④ in ); see also Establishing a Secure Connection .
5
6
Fig. 39: Establishing connection to the reader: search for
readers
The following steps describe establishing
the connection for readers with an IP
address.
3. In the Ethernet block, click Search for Readers (③ in
).
➯ The screen on the left appears.
4. Select a reader under
Readers with IP Address (⑤ in
the gure on the left).
5. If there have been 2 or more DHCP requests sent by
the reader, the
Readers without IP Address (DHCP)
eld (⑥) is expanded. Then it is possible to assign the
IP address to the reader.