User's Guide

83 of 146
1
2
3
Fig. 47: Ethernet section
Establishing a Secure Connection
✔ The connection to the reader has not yet been established.
1. In the Ethernet section, click the box next to the lock symbol (① in
).
2. Click
Search for Readers (②) or Connect (③).
➯ The following pop-up window appears:
1
2
3
4 5
3. Type in the user name at User (①). The default user name is root .
4. Enter the default password
UHF-RFID-Dev at Password (②).
Tip
You can change the password under Linux module ▶ Connection cong ; see Linux Module.
5. If you want to use the key le instead, click the box at Key le (③).
➯ A pop-up window to select the key le opens.
6. Select the key le.
7. Click
OK to establish the secure connection.
➯ It is possible to congure the secure connection under
Linux module ▶ Connection cong ; see also Linux
Module.
Loading Factory Default Settings
When resetting the reader to factory default, the ReaderStart sends out a UDP broadcast cmd. It is only possible 30 sec-
onds after power rebooting.
Note that this command also resets the Linux module settings, such as Linux password, network name, IP
address, deactivates the auto start of the apps etc.
1. In the Ethernet section, click Search for Readers .
2. Select the reader onto which you would like to load the factory default settings.