User's Guide

84 of 146
Operating the Reader Using the ReaderStart Software
3. Right-click on the reader.
➯ The following pop-up message appears:
4. Click Load factory defaults on this Reader .
➯ The pop-up message
Are you sure to load factory defaults on this reader appears.
5. Click
Yes to set the reader to the factory default settings.
Click
No to cancel.
➯ If you have clicked
Yes , another pop-up window appears:
6. Click Start .
➯ A pop-up message
Are you really sure to load factory defaults on this reader appears.
7. Click
Yes to set the reader to the factory default settings.
➯ The status messages informing about the progress of the reset process are shown in the
Status eld of the
pop-up window, see examples in the gure above.
8. After the factory default settings have been loaded onto the reader, click
Close .
Selecting a Favourite Reader
If there are many readers in the system and the user establishes connection to one reader more frequently than to the
others, it is possible to select the preferred reader as a favourite reader, placing it at the top of the reader list.
1. In the Ethernet section, click
Search for Readers .
2. Select the preferred reader.
3. Right-click on the reader.
➯ The following pop-up message appears: