User's Guide

88 of 146
Operating the Reader Using the ReaderStart Software
If the interface has been congured incorrectly, it is not possible to establish a connection to the reader.
► Note the following default conguration settings:
Name UHF-RFID-Dev
IP address 192.168.0.1
Subnet mask 255.255.255.0
Keep-alive
time
2000 ms
DHCP deactivated
Wi-Fi
3
5
3
4
5
6
7
8
1
10
2
9
11
12
13
14
16
17 18 19
20
21
15
Fig. 8: Communication conguration Linux model: Wi-Fi
①
Refresh reads the current settings of the communication conguration Linux module
②
IP4 see Fig. 46
③
IP6 enters the second IPv6 address (the rst IPv6 address is the link local address)
④
Status shows the status of the Wi-Fi connection
⑤
IP address shows the current IP address
⑥
SSID shows the name of the access point
⑦
MAC shows the MAC address of the access point
⑧
Frequency shows the frequency of the Wi-Fi connection
⑨
IsOnline shows whether the Wi-Fi module is online
⑩
Quality shows the quality of the connection
⑪
Get status reads the current status of the Wi-Fi module
⑫
Go online establishes the Wi-Fi connection