User's Guide

107 of 146
1)
All Generation 3 readers have GPIO.
⑥
Last antenna the last antenna for the selected function
⑦
Turn-o time
sets the time for how long the output is on for the Tag found and Tag operation successful
function
⑧
Get reads the current IO conguration settings
⑨
Set sets the output settings
16.6.2 Test Input and Output
2 3
1
4
5
6 7
Fig. 64: GPIO: Test Input and Test Output
Test Input
Each input channel has two conguration parameters available:
①
Input 1 – 4
shows logical input 1–4; will only be shown if Invert logical input for the respective input has been
checked at IO Conguration (① in Fig. 62,p.106 )
②
Read inputs reads the inputs once
③
Read inputs
cyclic start/
stop
reads the inputs in a loop/stops the reading
Test Output
④
Output
selects output 1–4 by means of the drop-down menu
► In order to use this function, select the
Protocol access function for the respective output (see
IO Conguration, p.106 and Selecting Functions, p.104 ).
⑤
Duration
sets time in ms after which the output automatically returns to its idle mode either by moving the
bar or by entering the value
If the duration is set to its maximum value (65535), the output is permanently on.
⑥
Set output on switches on the output
⑦
Set output o switches o the output