User's Guide

108 of 146
Operating the Reader Using the ReaderStart Software
16.6.3 Action List and Assign Input to Action List
To automate the processes, it is possible to store command sequences on the reader in the form of action lists. These
are triggered by a change of edge at the selected input.
2
3
1
4
5
6
7
8
9
10 11
Fig. 65: GPIO: Action List and Assign Input to Action List
Action List
Each input channel has two conguration parameters available:
①
Action list selects an action list (0–127) from the drop-down menu to save the action in
②
Action
selects an action from the drop-down menu, e.g. Activate buzzer (500 ms), SyncGetEPCs, ASyn-
cGetEPCs, ASyncStopCommand ; see also Adding Actions to the Programme, p.109
► To see the commands contained in the current action list, type in %userprofile%\Docu-
ments\KATHREIN Solutions GmbH\ReaderStart v3 into the Windows search eld.
③
Add action
adds action; the action is shown under Details (⑤)
④
Clear action
list
deletes actions; no actions are seen under Details (⑤)
Tip
To remove only one action from the list:
1. Select an action from the list shown under
Details.
1. Right-click on the selected action.
➯ The pop-up message
Remove entry appears.
2. Click on
Remove entry to delete the action.
➯ The action is deleted from the list.
⑤
Details shows added actions in the chronological order as they have been selected
⑥
Get action list shows the current action list
⑦
Set action list
saves the set action list (ashes blue after having added an action to the Details (⑤)
Assign Input to Action List
⑧
Action list
selects an action list (0–127) from the drop-down menu to assign to the input in (⑨)
⑨
Input assigns the action list to input 1–4 from the drop-down menu
⑩
Assign to
rising edge
assigns the action list to the rising edge
⑪
Assign to
falling edge
assigns the action list to the falling edge