Sat/TV/FM Test Receiver Operating Manual
Table Of Contents
- Start page
- Preface
- Contents
- Important Notes
- Safety Instructions
- Functions
- Displays, Operating Elements and Connections
- Operating Concept
- Operation
- Accumulator and Battery Operation
- Connections
- Measurement Possibilities
- Sat Operation
- Digital Measurements
- TV Operation
- Return Path IF Menu
- IF RP DIGITAL Menu
- Radio Operation
- AV Menu
- MPEG Decoder Menu (Optional)
- Setting Menu
- Screen Menu
- System Menu
- Copy Menu
- Mode Menu
- Text Menu
- Scope Menu
- Audio Scope
- DiSEqC Scope
- Spectral Menu
- Const Menu
- DVB-T
- Broadband Cable Analysis Measuring System MSK 33 / MVG
- Auto Measure
- Interfaces
- Maintenance, Storage and Customer Service
- Technical Appendix
- Technical Data
- Downloading New MSK33 Operating Software
- Notice
Radio Operation
53
Radio Operation
RADIO menu
Returns to TV menu.
Entering a frequency from 44.75
MHz to 867.20 MHz
The field lights up yellow as soon as the
softkey is pressed. Now,
the frequency can be
entered in with the nu-
merical buttons, „0...9,“
and the „MHz“ button or
changed with the cursor buttons, ◄►.
The frequency is displayed on the screen
in the lower left-hand corner.
RADIO CONTROL menu
In this menu, all remotely controlled parameters such as remote feed voltage, 22
kHz, DiSEqC, tone burst (Simple DiSEqC) and V-SEC can be set.
ANALOG menu
In this menu, min./max. level measurements are possible and the „level beep“ can
be activated.
RADIO ANALOG menu
Level-dependant acoustic signal
In the function, „level
beep,“ a acoustic signal
is generated, whose
pitch is proportional to
the received signal level.
With this signal, it is possible to optimally
align the receiving antenna to a transmit-
ter.
Carrying out measurements
By pressing the button, the following value
are measured:
- Minimal and maximal
level (min/max)
Level measurement
The reception frequency can be changed by using the cursor buttons, ◄►.