Operation Manual

936.2391/D/0806/2.12e
Type BAS 62
Application For stationary use
Reception range GHz 10.70-12.75
LNB noise fi gure dB Typ. 0.8
Gain dB > 50
Half power beam width ° < 3 (at mid-band)
LNB 1 output switchable, H/V, high/low
Switch-over
Low-Band
High-Band
kHz
kHz
0
22
Output frequency MHz 950-1950/1100-2150
Oscillator frequency GHz 9.75/10.6
Figure of merit (G/T)
11.3/12.5 GHz dB/K 13.3/13.7
LNB supply voltage V vertical: 11.5–14.0 – horizontal: 16.0–19.0
Current drain, max. mA 160
Wind surface m
2
max. 0.25
Wind load N 240 at dynamic pressure of 800 N/m
2
(Wind velocity: 130 km/h) and elevation = 0°
For installation higher than 20 m above ground, the wind velocity
must be multiplied with the factor 1.37.
That corresponds to a wind velocity of 150 km/h.
Clamping range mm 38-60
Weight kg 6,9
5. Important information
Before you begin to install, connect or utilise the antenna, observe the information you fi nd in these mounting
instructions.
If you fail to pay attention to the information, one cannot exclude:
• that due to wrong installation and connecting, or because of having modifi ed components or using foreign
components, the antenna or the mounting site can be damaged
• that because of inappropriate behaviour, risks for your and other people´s health and life will be created
• that the manufacturer will decline the liability for faulty function and resulted damages
It is most important that you are aware of the responsibility you have for your own and other people´s safety
when working on the antenna system.
Advice: Save these instructions for possible later use when questions come up.
In case you sell the antenna, hand over the instructions to the new owner.