Technical data

936.3347/A/0508/15.72d/e/f/it/es
1. PROPER USE (USE FOR THE INTENDED PURPOSE)
The BAS 65 planar antenna is to be used exclusively for the reception of satellite signals in the analogue and digital
frequency ranges and is only intended for private use as a household antenna*
)
. The BAS 65 planar antenna is
only designed for stationary use and may be installed at a maximum height of 20 meters above ground level.
Any use other than that specifi ed above will void the warranty or guarantee.
The antenna fulfi ls the requirements of EN 50083-1 (this standard is authoritative for general use of the BAS 65
planar antenna).
*
)
A household antenna refers to an antenna with a free mast length of maximum 6 m and a clamping torque of up to 1650 Nm
(see also DIN 4131).
The following circumstances result in the loss of all warranty and liability claims towards the manufacturer:
• Improper installation
• Use of non-specifi ed mounting materials, which cannot guarantee the mechanical reliability of the antenna
system
• Non-permissible use, e.g. use of the planar antenna for storage
• Structural changes or interference with the components and mounting accessories in the set, which could
endanger both the mechanical and functional reliability
• Improper or forcible opening of the components
• Use of cleaners containing solvents, such as acetone, nitro-cellulose combination thinners, petrol etc.
• Failure to observe installation and safety instructions in this manual
2. Scope of delivery (Fig. A)
The BAS 65 planar antenna is preassembled in the factory before delivery. The enclosed components shown in the
picture below are exceptions to this.
U-bolts (2 x) and nuts (4 x)
for mast installation with
Ø 42-50 mm
Hexagon wrench for tightening
the supplied screws
F-connector for mounting on
the antenna cable(s)
Installation support for wall,
mast and ground installation
Screws (4 x) for attaching the
antenna to the installation
support
Cable sleeves