Operation Manual

OPERATION

SELECTION OF THE CHANNEL TO BE MEASURED

Now the required measuring channel can be selected:

In principle there are various ways you can select the channel

1. Selection of a programme using the programme names

1.1. Select the required channel table using the “Chan.Tab” button.

1.2. The required programme name can be entered in the “Prog.Name” ﬁ eld (here the programme

name is automatically completed).

2. Selection of the programme via the channel number

2.1. Select the required channel table using the “Chan.Tab” button.

2.2. The number for the required programme position can be entered using “Prog.Number”.

3. Selection of a programme using the channel

3.1. Select the required channel table using the “Chan.Tab” button.

3.2. The required channel can be selected in the “Channel” selection.

4. Selection of a programme using the frequency

4.1 Select the required channel table using the “Chan.Tab” button.

4.2 The required frequency is entered in the “Frequency” ﬁ eld.

4.3 The frequency entry is automatically corrected to the correct video carrier frequency or channel

mid-frequency. You can ﬁ ne tune the frequency using the “<” and “>” buttons.

If the “Couple Chan” function on the “EXTEND” menu is set to “TO STAND.”, all further settings

(Standard, Mapping, Symbol Rate etc.) are made automatically.

If you want to set these parameters individually, you must set the “Couple Chan” function on the

“EXTEND” menu to “NOT COUP.”.

SELECTION OF THE MEASUREMENT

To make a measurement after completing the setting of the channel, the related measuring instrument

can be opened using the

hard key and subsequent selection via the onscreen menu.

The following measurements and measuring instruments can be selected:

Sub-menu for settings DiSEqC

, SCIF, etc.

Spectrum analyser

Constellation analyser

Pulse / reﬂ ection measurement (only for DVB-T)

Read MPEG stream, MPEG monitor

Storage oscilloscope

Summary measurement, simultaneous measurement of RF level, S/N, MER, BER, HUM and

video voltage

TV picture, videotext

Setting for the various outputs (ASI, TS parallel, video)