Specifications

3 / 11

The setting of the 8-way transmodulator DVB-S(2)-QAM (QPSK/8PSK on QAM) is done through the UFG 300 hand controller.

Required controller software version: from version V9.70

For setting up, connect the controller to the module (contains channel units I1 to 8).

The buttons speciﬁ ed below apply to the hand controller (see also the instructions for the UFG 300 hand controller).

Note: The settings and numerical values shown below are intended as an example and do not necessarily match the

delivery status.

The desired channel unit (1 to 8) is selected using the “<<” or “>>” buttons.

The desired parameter is selected using the “<” and “>” buttons.

The selected parameter ﬂ ashes in the display.

The setting is performed using the “+” and “-” buttons and where necessary using the “Change setting mode” button .

The sub-menus are activated and deactivated by pressing the “Sub-menu” button .

Finally, press “M” to save the setting in the module.

Setup instructions

Note: If the controller is disconnected from the module by pressing the “M” button without saving the settings, after

around 20 minutes the settings that had last been saved in the module become active again.

O1 1236 MHz

* P TP

27.500 MS/s 3/4 QPSK

Outp. * S21 306.00 MHz

6.900 MS/s

256 QAM

Main menu (all symbols shown)

The following representation shows the display after plugging in the controller:

(*) Left of “TP”:

Indicates “desired operating mode not yet reached”, displayed continuously in the event of an error.

If the indicator (*) is ﬂ ashing, the channel unit cannot reach its proper operating mode.

The reasons for this include:

• Input frequency or symbol rate set incorrectly

• No input signal

• Front end not clicked into place

Right of “Outp.”:

The channel unit output is switched off.

(!) The exclamation mark indicates that the settings of the output symbol rate and QAM stage is not sufﬁ cient for processing

the input data rate (i.e. the input data rate is greater than the output data rate).

• without the programme ﬁ lter a defective output signal will be output

• with the programme ﬁ lter the data rate can be sufﬁ ciently reduced by ﬁ ltering out individual programmes.

The exclamation mark indicates here that the user should check the correct operation

(P) Left of “TP”:

The “P” indicates that the programme ﬁ lter is activated and that some programmes may be removed from the transport

stream.

Displays