Specifications

5 / 11
O1
1236
MHz TP
27.500 MS/s 3/4 QPSK
Outp. S21 306.00 MHz
6.900 MS/s 256 QAM
Main menu Main menu (example for digit-by-digit setting)
O1
1236
MHz TP
27.500 MS/s 9/10 QPSK
Outp. S21 306.00 MHz
6.900 MS/s 256 QAM
The input frequency in the active channel unit is selected using the “<” and “>” buttons. The input frequency can be set continuously
from 950 MHz to 2150 MHz in 1 MHz steps using the “+” and “-” buttons.
The setting can also be made on a digit-by-digit basis:
• Press the “Change setting mode” button (starts mode)
• The fi rst digit fl ashes and can be input directly using the buttons on the keyboard
• After the fi rst digit has been input, the second fl ashes, and so on
• To make a correction, press the “Back” button to skip one place to the left
• After the last digit has been set, press the “Change setting mode” button to end the mode
The current SNR and the automatically detected operating mode, DVB-S or DVB-S2 of the front end are displayed in the input
frequency sub-menu.
Pressing the “Sub-menu” button displays the sub-menu and pressing the sub-menu button again exits it.
1.3 Selecting input frequency
Note: Always select the input frequency fi rst and then the output level.
O1
1236
MHz TP
27.500 MS/s 3/4 QPSK
Outp. S21 306.00 MHz
6.900 MS/s 256 QAM
Main menu
** UFO 378TP-O1 **
SNR
--.-dB
BER
-.-E---
Standard
-----
Sub-menu for “Input frequency” (no signal)
The displays of SNR, BER and DVB operating modes are valid only in regular operation with the front end clicked into place.
** UFO 378TP-O1 **
SNR
15.2dB
BER
0.0E-00
Standard
DVB-S
Sub-menu for “Input frequency” (signal available)
Note: For the SNR, BER and DVB standard display all the parameters must be set and the indicator (*) may not be
fl ashing. Trouble-free operation of the systems requires: SNR > 12 dB