Operating instructions

Satellite

Using the



buttons, select the satellite to be scanned. Make sure your reception system is aligned to

the selected satellite. You can search only one satellite at a time. If you have connected a multi-feed reception

system (e.g. reception of ASTRA 19.2° East and HOTBIRD 13° East), you must repeat this procedure once

for each satellite. You can however start the ﬁ rst installation again, in the course of which a channel search

of all the satellites you selected is performed.

Press the



button to move to the next selection item.

Channel Search Mode

Use the



buttons to select whether you wish to search “free & encrypted” or “only free” channels.

Press the



button to move to the next selection item.

Network Search

Use the



buttons (On/Off) to select whether a network scan should be performed. If you set the

network search to “Off”, only the factory stored transponders of the satellites you previously selected will be

searched for new as yet unlisted channels.

If you set the network scan to “On”, the transponder network enables additional transponders that have not

yet been stored to be located. They are then stored and searched for new channels in the same way as the

existing transponders.

When you have made your settings, use the



buttons to select “Start Search” and press the



button to start scanning. You can cancel the scan at any time by pressing the



button. During the search

you will see the following message (example):

TV channels

found

Radio

channels found

Progression bar

Satellite with the

transponder

currently being

searched

SEARCH CHANNELS (CHANNEL SEARCH)