Operation Manual

12
Buttons on the remote control required for fi rst installation:

...

Number input

(green)
Call up the next step in the
fi rst installation

(red)
Go back one step in the
fi rst installation

Confi rm the changed values/
setting; call up the submenus

Select/change individual
menu parameters, navigation

Cancel entry, go back
First switch your TV set on and select the AV-/HDMI input you have used to connect the receiver to
your TV set. Switch on the receiver at the power switch on the rear of the unit. Now perform the fi rst
installation. If you have any questions or encounter problems, contact your specialist dealer.
The following on-screen display appears:
Always check the bar at the
bottom of the on-screen display.
This provides information on
what to do next.
Use the

buttons to select the desired menu language for your UFS 946/CI+ and confi rm your
selection using the

button. The selected language is indicated with a tick. The following languages
are available: German, English, French, Italian, Spanish, Czech, Dutch, Polish, Turkish and Russian.
First installation
Connection and set-up
Before you start to use the UFS 946/CI+, read the sections “Safety instructions
- Important notes” and “Connection and set-up” through to the item “First
installation”.
Do not connect the unit to the mains until all installation work has been properly
carried out.
The guidance provided in the “First installation” section assumes that the receiver has been
properly connected as per the “Safety instructions - Important information” and “Connection
and set-up” sections through to the “First installation” section.
Tip!