Operation Manual

19
Connection and set-up
- Universal
- Simple or
- User-defi ned
If you do not use a Universal LNB, press the

button. You can now defi ne the settings for your LNB type
(simple or user-defi ned).
LNB Frequencies (MHz):
Enter the LNB frequencies (Low/High/Limit) using the number pad. Now use the

button to save the
new values.
Uncommitted Switch
Set the “Uncommitted Switches” here to match the
confi guration of your reception system. You can
select “Off” or a value from “1” to “16” in single unit
increments.
Position
Select the fi eld “Position”. Set the “Position” here to match the confi guration of your reception system.
You can select “Off” or a value from “1” to “4” in single unit increments.
DiSEqC™ Repeat:
The setting for how often the DiSEqC™ command must be repeated depends on the confi guration of
your reception system. Refer to the documentation for your reception system or seek assistance from a
specialist engineer.
- Off DiSEqC™ command is not repeated
- 1 DiSEqC™ command is repeated once
- 2 DiSEqC™ command is repeated twice
- 3 DiSEqC™ command is repeated three times
Test-Transponder:
Select the “Test-Transponder” fi eld. Here you can select a transponder for checking whether your
settings are correct using the signal strength bar and signal quality bar.
When you have completed all settings for this satellite, press the

button.
If you wish to set up more than one satellite (64 max.) for the tuner, defi ne the settings as just described
for the fi rst satellite, for the second satellite and for any further satellites.
When you have completed all settings for the tuner, press the

(green) button.
Refer to the documentation for
your LNB or seek assistance
from a specialist engineer.
Refer to the documentation for
your reception system or seek
assistance from a specialist
engineer.