Operation Manual

Connection and set-up

On the “Satellite” line select the satellite whose settings you wish to edit.

Satellite:

Select the desired satellite using the



buttons. Alternatively you can press the



button to

view a list of all satellites which you have previously selected, then select the required satellites from

this list.

LNB Type:

If your reception system does not have a universal LNB, use the



buttons to select the LNB types

that are used in your reception system. You can choose from the following LNB types:

- Universal

- Simple or

- User-deﬁ ned

If you do not use a Universal LNB, press the



button. You can now deﬁ ne the settings for your

LNB type (simple or user-deﬁ ned).

LNB Frequencies (MHz):

Enter the LNB frequencies (Low/High/Limit) using the number pad. Now use the



button to save the

new values.

Test-Transponder:

Select the “Test-Transponder” ﬁ eld. Here you can select a transponder for checking whether your

settings are correct using the signal strength bar and signal quality bar.

Stop on Signal:

Select the selection ﬁ eld “Stop on Signal”. Here, you can select whether the turntable antenna should

stop its rotary movement immediately on reception of a signal from the desired satellite. You can choose

between “On” and “Off”.

Move Antenna:

Select the selection ﬁ eld “Move Antenna”. Here you can control the movements of the motorised

antenna, using the following buttons:



Start slow rotation to West



Rotate to the West step by step



Stop the current movement

Refer to the documentation for

your LNB or seek assistance

from a specialist engineer.