Operation Manual

27
Connection and set-up
On the “Satellite” line select the satellite whose settings you wish to edit.
Satellite:
Select the desired satellite using the

buttons. Alternatively you can press the

button to
view a list of all satellites which you have previously selected, then select the required satellites from
this list.
LNB Type:
If your reception system does not have a universal LNB, use the

buttons to select the LNB types
that are used in your reception system. You can choose from the following LNB types:
- Universal
- Simple or
- User-defi ned
If you do not use a Universal LNB, press the

button. You can now defi ne the settings for your
LNB type (simple or user-defi ned).
LNB Frequencies (MHz):
Enter the LNB frequencies (Low/High/Limit) using the number pad. Now use the

button to save the
new values.
Test-Transponder:
Select the “Test-Transponder” fi eld. Here you can select a transponder for checking whether your
settings are correct using the signal strength bar and signal quality bar.
If you have selected more than one satellite for Tuner 1, defi ne the settings as just described for the fi rst
satellite, for the second satellite and for any other selected satellites.
When you have completed all settings for the selected satellites, press the

button.
When you have completed all settings for the tuner, press the

(green) button.
The receiver will automatically display the screen for the channel search. Continue the fi rst installation
with the “Channel search” section.
Refer to the documentation for
your LNB or seek assistance
from a specialist engineer.