Operation Manual

Connection and set-up

Satellite:

Select the desired satellite using the



buttons. Alternatively you can press the



button to

view a list of all stored satellites then select the required satellites from this list.

Transponder Frequency:

Select the desired transponder using the



buttons. Alternatively you can press the



button

to view a list of all transponders stored for this satellite and then select the required transponder from

this list.

Test Ton:

Using the test tone you can have the unit output a tone via the TV set to assist with the alignment of

the mobile antenna. Select the required setting using the



buttons:

- On: The nearer the actual value is to the required value, the higher the tone becomes

- Automatic: You only hear a tone once the actual value is the same as the required value

- Off: You will not hear any tone

You can check whether your settings are correct using the signal strength bar and signal quality bar.

When you have completed all settings, press the



(green) button.

The receiver will automatically display the screen for the channel search. Continue the ﬁ rst installation

with the “Channel search” section.