Operation Manual

4
Product return/original packaging
Make sure that the ventilation slots on the unit are not blocked or covered in
any way. Otherwise the unit may overheat.
There is a risk of re!
Safety instructions - important notes
Please keep the original packaging in case you need to return the product at any time! The receivers
are fragile due to their construction and are only adequately protected by the original packaging.
If the receiver is not shipped correctly the guarantee/warranty on it will be voided.
Before you disconnect the receiver from the mains, you must switch it to the standby mode by pressing
the standby button (on/off) on the remote control. In standby mode, any changed or new data that
are broadcast will be saved by the receiver. As soon as the receiver is in the standby mode, it can be
disconnected from the mains at any time.
The information in these operating instructions was correct at the time of going to print. We reserve
the right however to make changes at any time and without prior notice. If new software is released for
your receiver, and this affects the information in the operating instructions (e.g. changes to the menus
and/or functions), if we believe it necessary we will make available new operating instructions for
download at “www.kathrein.de”.
Make a note of the receiver's basic settings (these are set during rst installation) so you can restore
them if necessary!
Please be aware of your responsibility towards your fellow human beings! Keep these
instructions for any questions that arise later, and if the receiver passes to another owner,
pass them on to the new owner.
Fan/ventilation slots on the unit
Switching the receiver off
Other
Warning!
You must not disconnect the receiver from the mains while it is in operation!
This can lead to a loss of data and corruption of the software.