Operation Manual

44
Connection and set-up
This menu can be found in the receiver
under: Mainmenu - Interface Setup -
Ethernet Settings. After calling up the
menu you will see the following on-screen
display (example):
The Ethernet interface used in the
receiver is a 10/100 base T Ethernet
interface.
If you want to connect your receiver to a DHCP server/router, use the

buttons to select the
“On” setting. If you wish to connect your receiver to a PC or laptop, the DHCP setting must be “Off”.
DHCP “On”
(DHCP server/router)
DHCP “Off”
(Hub/switch/direct
connection to PC or laptop)
Individual items are selected using the

buttons. Changes to the current settings can be made
using the

buttons or the numeric keypad.
An Internet connection is required to use HbbTV!
These settings should not be defi ned unless the receiver is linked into a network (e.g. for
Internet connection) or is linked to a PC/laptop using a cross-over network cable.
Refer to our network function connection examples at the end of these instructions as well
as the guidance we provide on this topic on the Internet at “www.kathrein.de” “Service” →
“Software and Download” → “Receiver” → “UFS 946”.
To connect the receiver to the network via the PC/laptop, you must have unrestricted rights
(administrator rights) for your PC/laptop and on your network.
If you experience problems connecting the receiver to your network directly or via your PC/
laptop, consult your PC or network specialist.
Network/Internet connection