Operation Manual

Connection and set-up

Remove the cover on the rear of the remote control. Insert the two batteries supplied into the remote

control. Ensure correct polarity of the batteries; the + and – markings are indicated inside the battery

compartment. Slide the cover back onto the housing until it locks in place.

Inserting batteries into the remote control

To open:

Gently press here and pull

backwards

So as to prevent the receiver slipping or

falling, the mounting kit can also be attached

to the underside of the receiver. Assembly

is the same as for suspended installation,

except that the mounting kit is attached to the

underside of the receiver.

Installation on a ﬁ xed ﬂ at surface