User's Manual

Assembly Instructions
56
Assembly Instructions
Appendix
2. Attaching the back board
Allow the assembled pedal board and side panels to stand
upright (vertically) on the oor.
* Ensure that the adjustor bolt is attached to the pedal board.
Loosely attach the back board (D) to the left and right side
panels using the four long black tapping screws
*.
Loosly attach the bottom of the back board to the pedal
board using the four mid-length black or silver tapping
screws
*.
Adjust the positioning of the pedal board, side panels, and
backboard to ensure that all parts are in alignment, then
tighten the screws in steps
and .
* For Satin White nished instruments, black screws will be replaced
with silver screws.
B
C
D
adjustor bolt
not aligned
Hole of pedal board/
side panel
Hole of
back board
* Make sure that the hole of the
back board is aligned with the
hole of the pedal board/side
panel before xing with the
screw.
1. Attaching the side panels to the pedal board
Unfasten and extend the pedal connection cable attached
to the bottom of the pedal board (E).
Attach the pedal board (E) to the left (B) and right (C) side
panels using the temporary mounting screws located on
either end of the pedal board.
Ensure that the pedal board and side panels make close
contact, and that there are no large gaps between the
assembled parts.
Insert the four short silver tapping screws into the holes
as shown, and securely fasten the pedal board to the left
and right side panels.
B
E
B B
B B
E E
E E
B
E
C
Pedal cable
temporary
mounting screw
gap