Operation Manual

7INTRODUCTION
3. Place the piano on the front half of the
stand so that the metal fitting holes are
seen when viewed from the top. Slide the
piano backward while holding it with one
hand so that it does not incline and fall
from the stand. The hooks on the piano
are then engaged with the metal fittings
on the Side Panels. Pay attention so that
your hand or fingers are not caught
between the stand and piano. Fasten the
piano and the stand with four bolts (F).
CAUTION: Be sure to secure the piano
to the stand with the screws. If you fail
to do so, the unit could fall from the
stand causing damage or personal
injury.
4. Insert the pedal connection cord that
comes from Pedal Board (C) into the
piano’s pedal jack and fasten with cord
clamp.
5. Turn the Adjuster (installed on the
bottom of C) until it touches the floor to
support the pedal board.
(F)
Hand or Finger
catching hazard
Bottom View