Instructions / Assembly

ASSEMBLY

U-Brake

1. Install the left brake arm onto pivot on the frame, assemble washer (C)

and the inner hex fixing bolt(A) without fastening them tightly.

Repeat the same procedure to assemble the right arm.

2. Position the brake pads and make sure they match well with th rim.

3. Turn 90 degrees clockwise to fasten the tension adjuster waster (B)

with a 19mm wrench. Then fasten inner hex fixing bolt with a 5mm

allen key.

4. Repeat steps 2 and 3 to fix the right arm.

5. Loosen the anchor bolt, then install the cable into the cable anchor nut

and then slide the cable under the tabbed washer of anchor bolt.

6. Squeeze both brake arms together so the brake shoes hit the rim pull

all slack out of the brake cable, and lighten the anchor bolt.

7. Adjust the brake shoes using a 10mm wrench so that they are parallel

with the rim and are positioned 1-2mm away from the rim. Several

adjustments may be necessary to achieve the correct brake position.

Warning: Cut off any unnecessary calbe, attach an end cap, and hook it.

Note: Both arms are equipped with return spring. To obtain a normal return

spring tension, adjust the tension adjuster washer(B) by rotating the

washer(B) to the right or to the left.

Link Fixing Bolt (A)

Washer (C)

Fixing Nut (B)

Brake Arm

Pivot

Brake Shoe

Rim