® ® Please read this manual and save it with your original sales receipt. Tools needed for assembly: Phillips Screwdriver, Hammer and Adjustable Wrench (all not included); Cap Nut Assembly Tool (included). Use only with a Power Wheels® 12 Volt Battery with Built-in Thermal Fuse and a Power Wheels® 12 Volt Charger (both included). KAWASAKI AND NINJA ARE TRADEMARKS LICENSED BY KAWASAKI MOTORS CORP., U.S.A., WHICH DOES NOT MANUFACTURE OR DISTRIBUTE THIS PRODUCT.
Table of Contents A B C D E F G H I J K L M N Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Warnings and Caution . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
B Warnings and Caution ELECTRICAL HAZARD WARNING • Battery can fall out and injure a child if vehicle tips over. Always use battery clamp. • PREVENT FIRE - Never modify the electrical system. Alterations could cause a fire resulting in serious injury and could also ruin the electrical system. - Use of the wrong type battery or charger could cause a fire or explosion resulting in serious injury.
C Parts • If you experience a problem with this product, or are missing a part, please call us at 1-800-348-0751, rather than return this product to the store. • Please identify all parts before assembly and save all packaging material until assembly is complete to ensure that no parts are discarded. • Some parts were placed under the seat for shipment. Press the tab under the back of the seat and lift to access the battery compartment.
D Parts Diagram 3 16 2 7 8 6 5 1 13 12 6 9 12 13 5 10 4 5 15 14 14 15 17 18 15 6 10 6 4 5 11 1. 2. 3. 4. 5. 6. 7. Vehicle Handlebar Right Grip (with Large Hole) Front Wheel - 2 Hubcap - 4 Cap Nut - 4 Seat 8. 9. 10. 11. 12. 13. 14. 12 Volt Battery Rear Axle Bushing - 2 12 Volt Charger Rear Wheel Driver - 2 Rear Wheel (Wide) - 2 #10 x 3/4" Screw - 4 5 15. 7/16" Washer - 3 16. Left Grip (with Small Hole) 17. #8 x 3/4" Screw - 1 18.
E Battery Charging ELECTRICAL HAZARD Important Notes • Your new battery must be charged for at least 18 hours before you use it in your vehicle for the first time. • We recommend that you start charging your battery before beginning assembly of your new vehicle. • You do not need to remove the battery from your vehicle to recharge it. • The battery must be upright while charging. • The charger is not a toy. • Do not short circuit the battery.
F Assembly 2 WARNING Rear Wheel Driver (Ring Side Down) Rib Up Children can be harmed by small parts, sharp edges and sharp points in the vehicle’s unassembled state, or by electrical items. Care should be taken in unpacking and assembly of the vehicle. Children should not handle parts, including the battery, or help in assembly of the vehicle. Rear Wheel Hubcap (Indented Side Down) 1 Rear Axle • Slide a hubcap, indented side down, onto the rear axle. • Locate a rear wheel.
Assembly 4 Hubcap (Indented Side Out) 6 Rear Wheel Rib Rear Wheel Driver (Ring Side Out) Steering Column Large Opening Rear Axle • Slide the other rear wheel driver, ring side out, onto the rear axle. Make sure the rear wheel driver fits onto the pins in the motor assembly inside the vehicle. • Slide the other rear (wider) wheel onto the rear axle. Make sure the ribs on the rear wheel fit into the grooves on the rear wheel driver. • Slide a hubcap, indented side out, onto the rear axle.
Assembly Hooked End of the Steering Column 8 10 Steering Linkage • Insert the #8 x 3/4” screw through the hole in the end of the steering column, so that the screw head faces the front of the vehicle. • Fit the #8 lock nut onto the end of the screw. Make sure the rounded side of the lock nut faces the rear of the vehicle. • While holding the lock nut steady with an adjustable wrench, tighten the screw with a Phillips screwdriver. Do not over-tighten.
Assembly 12 Front Axle Bushing (Ring End First) Front Wheel (Flat Side First) 14 Right Grip Left Grip Large Hole Small Hole Washer Hubcap (Indented Side Out) • Turn the vehicle upright. Note: The left and right grips are not interchangeable! The hole in the left grip is smaller than the hole in the right grip. • Fit the left grip on the end of the left handlebar. • Fit the right grip on the end of the right handlebar.
G Label Decoration Proper label application will help to keep the labels looking their best! When applying labels, keep the following guidelines in mind: • Wash your hands before applying the labels. • Before applying the labels, wipe the surface of the vehicle with a clean, dry cloth to remove any dust or oils. • Place the labels exactly as shown in the illustrations. • For best results, avoid repositioning a label once it has been applied to the vehicle.
H Battery Installation IMPORTANT! Use only a Power Wheels® 12 volt battery with built-in thermal fuse. Use of any other battery will damage your vehicle. Make sure that you charge the battery for at least 18 hours using the enclosed Power Wheels® 12 volt charger before operating your vehicle for the first time. Charge the battery for at least 14 hours after each use of the vehicle. Never charge the battery longer than 30 hours.
I Battery Care and Disposal Care Disposal If a battery leak develops, avoid contact with the leaking acid and place the damaged battery in a plastic bag. See information below for proper disposal. If acid comes in contact with skin or eyes, flush with cool water for at least 15 minutes and call a physician. If acid is internally ingested, give water, milk of magnesia or egg whites immediately. Never give emetics or induce vomiting. Call a physician.
K Rules for Safe Driving RIDING HAZARD WARNING Prevent Injuries and Deaths • Direct Adult Supervision Required • Keep Children Within Safe Riding Areas These areas must be: - away from swimming pools and other bodies of water to prevent drownings - generally level to prevent tipovers - away from steps, driveways, cars, roads and alleys. Use vehicle on generally level ground ONLY! 7. Do not allow your child to drive on sloped or inclined surfaces.
L How to Operate Your Vehicle IMPORTANT! As assembled, your vehicle is ready to roll in low speed (21/2 mph, maximum). When your child is ready to drive the vehicle in high speed (5 mph, maximum), follow the instructions on this and the next page to connect the high speed hook-up and use the power boost button. Stop Drive Drive • Your vehicle has a patented, electronic braking system that automatically stops the vehicle when your child’s foot is lifted from the pedal.
M How to Operate Your Vehicle High Speed IMPORTANT! To avoid damaging the motors and gears, stop the vehicle before shifting between low and high speed. Statement of Limited Warranty *One year limited warranty from the date of purchase on the Power Wheels® vehicle. Six month limited warranty on the 12 volt battery. For the original purchaser, this one year limited warranty covers the Power Wheels® ride-on vehicle (purchased from Power Wheels®) against defects in materials and workmanship.
N Problems and Solutions Guide IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions Guide below. If you still experience a problem, please contact Power Wheels® Consumer Relations, toll-free at 1-800-348-0751 between 8 AM and 6 PM (EST) Monday through Friday. Or, contact your local Power Wheels® authorized service center. For the location nearest to you, please visit us on-line at www.powerwheels.com or call 1-800-348-0751.
Problems and Solutions Guide Problem Vehicle was running but suddenly stopped Short run time (less than 1 - 3 hours per charge) Possible Cause Solution Loose wire or loose connectors Check all wires and connectors. Make sure the motor harness connector is tightly plugged into the battery, and that there are no loose wires around the motors. Tripped thermal fuse Each Power Wheels® 12 volt battery has a built-in thermal fuse.
Problems and Solutions Guide Problem Vehicle runs sluggishly (cont.) Possible Cause Possible Cause Solution Solution Battery needs charging Be sure to charge the battery after each use. Battery is old and will not accept accept full charge Even with proper care, a rechargeable battery does not last forever. Average battery life is 1 to 3 years depending on vehicle use and use conditions. Replace only with Power Wheels® 12 volt battery with built-in thermal fuse. Do not substitute parts.
IMPORTANT! DO NOT use this vehicle for the first time until you have charged the battery for 18 hours. Remember to… ✔ Charge the battery immediately after each use. ✔ Charge the battery once a month during storage, even if the vehicle has not been used. Failure to follow these instructions will permanently damage your battery and void your warranty. Please refer to the Battery Care Section in this manual for more information.