Service Manual

3-94 FU EL SYSTEM (DFI)
Throttle Body Assy
•
Remove the following from the choke cable holder [A] (left
-behind view).
Screw [B]
Choke Cable Plate [C]
•
While pushing the choke lever [A] forward, remove the
cable housing from the choke cable holder [B] and the
inner cable out of the holder slit [C].
•
Take off the lower end [D] from the choke l ever.
Front [E]
•
Remove the screws and take off t he right switch housing.
•
Remove the accelerator cable end [A] and decelerator
cable end [B] at the throttle grip.
•
Pry open the staking [C] on the throttle cable holder [E],
and remove the cable clip [D].
Rear View [F]
(for reference)
Accelerator Cable [A] and Decelerator Cable [B]
CAUTION
Do not remove the throttle cable holder. If the
holder is damaged, replace it along with the throttle
assy.
•
Turn the throttle pulley [A] as shown, and pull out the ac-
celerator cable housing [B] from the cable holder [C] (rear
view).
•
Return the pulley, and pull out the decelerator cable hous-
ing [D] from the cable holder.