User's Manual

WHEELS/TIRES 10-15
Hub Bearing
Hub B earing Rem oval
•
Remove the wheel, and take out the following.
Collars
Coupling (out of rear hub)
Grease Seals
Circlip
•
Use the bearing remover to remove the hub bearings [A].
CAUTION
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Please blocks under the wheel so that the disc does
not touch the ground.
Special Tools - Bearing Remover Head, 20 × 22:
57001–1293 [C]
Bearing Remover Shaft,
13: 57001–1377
[B]
Hub B earing Installation
•
Before installing the wheel bearings, blow any dirt or for-
eign particles out of the hub with compressed air to pre-
vent contamination of the bearings.
•
Replace the bearings with new ones.
NOTE
○
Install the bearings so that the marked side faces out.
•
Install the bearings by using the bearing driver set which
does not contact the bearing inner race.
•
Press in each bearing [A] right until they are bottomed.
Special Tool - Bearing Driver Set: 57001–1129 [B]
•
Replace the circlip with a new one.
•
Replace the grease seals with new ones.
•
Press in the grease seals [A] so that the seal surface flush
[B] with the end of the hole.
○
Apply high temperature grease to the grease seal lips.
Special Tool - Bearing Driver Set: 57001–1129 [C]
Hub B earing Inspection
Since the hub bearings are made to extremely close tol-
erances, t he clearance can not norm ally be measured.
NOTE
○
Do not remove any bearings for inspection. If any bear-
ings are removed, they will need to be replaced with
new ones.
•
Turn each bearing in the hub back and forth [A] while
checking for plays, roughness, or binding.
If bearing play, roughness, or binding is found, replace
the bearing.
•
Examine the bearing seal [B] for tears or l eakage.
If the seal is torn or is leaking, replace the bearing.