User's Manual

ELECTRICAL SYSTEM 16-79
Switches and Sensors
•
Connect the test light [A] ( 12 V 3.4 W bulb a socket with
leads) and the 12 V battery [B] to the fuel level sensor
connector [C].
Connections:
Battery (+) → 12 V 3.4 W Bulb (one side)
12 V 3.4 W Bulb (other side) → Blue Lead Terminal
Battery (–) → BK/Y Lead Terminal
If the test light turn on, the reverse switch is defective.
Replace the fuel level sensor.
•
Remove:
Fuel Level Sensor (see Fuel Level Sensor Inspection)
•
Connect the test light (12 V 3.4 W bulb in a socket with
leads) and the 12 V battery to the fuel pump connector as
shown.
12 V Battery [A]
Test Light [B]
Fuel Pump Connector [C]
Fuel Reserve Switch [D]
If the test light doesn’t light, replace the fuel level sensor.
NOTE
○
It may take a long time to turn on the test light in case
that the fuel reserve switch i s i nspected just after the
fuel level sensor is removed. Leave the fuel reserve
switch with leads for inspection connected for ten (10)
minute.
Diode (Rectifier) Inspection
•
Remove the fair
ing (see Frame chapter)
•
Cut t he vinyl tape [A].
•
Disconnect the diode [B].
•
Set the hand tester to the × 100 Ω range.
Special Tool - Hand Tester: 57001–1394
•
Check the continuity between the diode terminals in both
directions.
If there is continuity in one direction (forward direction) but
no continuity (infinity) in the reverse direction, the diode
is normal.
The diode is defective if there is continuity after changing
the direction, or it if remains with no continuity.
NOTE
○
The actual resistance measurement in the f orward
direction varies with the tester used and the individual
diodes. Generally speaking, it is acceptable if the
tester ’s indicator swings approximately halfway.