User's Manual

APPENDIX 17-11
Cable, Wire, and Hose Routing
1. Clamp t he position of branch harness and front right turn signal light lead.
2. Run the meter harness into the hole of cover.
3. Meter
4. Set the cover to cover all of the connector.
5. Clamp the right and left switch housing lead and front left turn signal light lead.
6. To left switch housing
7. To front left turn signal light
8. To right switch housing
9. Headlight high and low
10. Running position light
11. Install the lead with its inner side facing inward.
12. To front right turn signal light
13. Clutch cable
14. Starter cable
15. Run the ignition switch lead in front of clutch and starter cable.
16. Run the leads for the clutch, starter and the ignition switch in order from the head pipe and in
front of these, run the both throttle cables as decelerating one is outer.
17. Throttle cable (Run the cable in rear of the main harness.)
18. Brake hose
19. Main harness
20. Connect green tape side to left head lamp.