Instructions / Assembly

INSTALLATION (continued)
5
Assembling the canopy assembly
to the outlet box
6
Installing the light bulbs
Page 4 of 4
• Place the canopy assembly (A) over the outlet
box, align the two holes of the mounting bracket
(H1) and the canopy of the canopy assembly (A),
then tighten the support screws (short) (H2).
• Install the light bulbs (not provided) into the
sockets. Use four 60 W candelabra base (E12)
type "B" bulbs (recommended).
Note: You can also use four 9W candelabra base
(E12) self-ballasted LED bulbs. Do not exceed
the recommended wattage.
H2
H1
A
D
CLEANING
• Use only a dry soft cloth to dust and clean your new lamp.
• Do not use any chemicals, polishers or abrasives.
QUESTIONS?
For customer service support and the fastest response, please email us at
[e-mail].
TROUBLESHOOTING
• The light does not come on at all:
a) Make sure the wall switch and circuit breaker are on.
b) Make sure the wiring is correct.
• Fuse blows or circuit trips when light is turned on.
a) Check for crossed wires, ensure wiring is correct.