Instructions / Assembly

INSTALLATION (continued)

Installing the light bulbs

Assembling the finials and glass

shades

Page 4 of 4

• Install the light bulbs (not provided) into each

socket. Use four MAX 60 W medium base (E26)

type "ST64" bulbs (recommended).

Note: You can also use four MAX 60 W medium base

(E26) type "A" bulbs or MAX 9W medium

base (E26) self-ballasted LED bulbs. Do not

exceed the recommended wattage.

• Tighten the two finials (A) to fixture body (B).

• Unscrew the socket rings (H8) from the sockets

on the fixture body (B). Set the glass shades (C)

onto each socket, and secure them with the

socket rings (H8).

CLEANING

• Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry, soft cloth to dust or

wipe carefully.

• To clean the fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the

fuse box. Use a dry or slightly dampened, clean cloth to wipe the exterior surface of the fixture.

TROUBLESHOOTING

• The light does not come on at all:

a) Make sure the wall switch and circuit breaker are on.

b) Make sure the wiring is correct.

• Fuse blows or circuit trips when light is turned on.

a) Check for crossed wires, ensure wiring is correct.