Instructions / Assembly

INSTALLATION (continued)
Page 3 of 4
3
Making the electrical connections
• Strip 3/4 in. of insulation from the wire ends.
• Connect the black wire from the fixture to the
black wire from the outlet box, then connect the
white wire from the fixture to the white wire
from the outlet box.
• The bare copper ground wire from the fixture
must loop one turn under the head of the green
ground screw (H5) on the mounting bracket (H1)
before it is connected to the ground conductor of
the supply circuit.
• Cover the wires with wire connectors (H6). Tape
the wire connectors (H6) and wires together, and
carefully position all wires inside the outlet box.
H6
H5H1
H1
H2
H7
B
B
4
Assembling the fixture body to the outlet box
• Place the fixture body (B) over the outlet box, and ensure the heads of the support screws (long) (H2)
come through the holes of back of the fixture body (B).
• Tighten the cap nuts (H7) onto the protruding support screws (long) (H2) on the mounting bracket (H1)
until the fixture body (B) is held firmly against the wall.
Note: The shades on this fixture can be installed facing up or facing down.
OPTION 1: Mount with glass
shades facing down.
OPTION 2: Mount with glass
shades facing up.