Instructions / Assembly

INSTALLATION (continued)
6
Installing the light bulbs
5
Assembling the finials and glass
shades
Page 4 of 4
• Install the light bulbs (not provided) into each
socket. Use three MAX 60 W medium base (E26)
type "ST64" bulbs (recommended).
Note: You can also use three MAX 60 W medium
base (E26) type "A" bulbs or MAX 9W
medium base (E26) self-ballasted LED bulbs.
Do not exceed the recommended wattage.
• Tighten the two finials (A) to fixture body (B).
• Place the glass shade (C) over the socket, align
the three holes of the glass shade (C) and cap of
the socket on the fixture body (B), then secure
the glass shade with the thumbscrews (H8) as
shown on the diagram.
CLEANING
• Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry, soft cloth to dust or
wipe carefully.
• To clean the fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the
fuse box. Use a dry or slightly dampened, clean cloth to wipe the exterior surface of the fixture.
TROUBLESHOOTING
• The light does not come on at all:
a) Make sure the wall switch and circuit breaker are on.
b) Make sure the wiring is correct.
• Fuse blows or circuit trips when light is turned on.
a) Check for crossed wires, ensure wiring is correct.
B
A
B
C
H8