Instructions / Assembly

INSTALLATION (continued)

Page 3 of 4

Making the electrical connections

• Strip 3/4 in. of insulation from the wire ends.

• Connect the black wire from the fixture to the

black wire from the outlet box, then connect the

white wire from the fixture to the white wire from

the outlet box.

• Connect the bare copper ground wire to the

ground wire from the outlet box. The bare copper

ground wire from the fixture must loop one turn

under the head of the green ground screw (H5) on

the mounting bracket (H1) before it is connected

to the ground conductor of the supply circuit.

• Cover the wires with wire connectors (H6). Tape

the wire connectors (H6) and wires together, and

carefully position all wires inside the outlet box.

Installing the fixture body to the outlet box

• Place the fixture body (A) over the outlet box, and ensure the heads of the support screws (long) (H2)

come through the holes of back of the fixture body (A).

• Tighten the cap nuts (H7) onto the protruding support screws (long) (H2) on the mounting bracket (H1)

until the fixture body (A) is held firmly against the wall.

Note: The whole fixture can be installed facing up or facing down.

OPTION 1

OPTION 2